Place to your file particles stock (below model, above gradient layer). Change blending mode to Screen and opacity to 69%.
Repeat this step. I used three particles layers on background (with the same settings).
If everything is clear, it’s time to make a mask. Place stock into the file. Isolate part of it as is shown (by masking).
Add adjustment layer with Curves. Make it clippy. It gives unitary tone for the whole stock.
Next, add clipping adjustment layer with Hue/Saturation. It will give better possibility to adjust everything to background and model.
On this adjustment layer add mask. With gray, soft brush erase some places. Leave only top of the prop.
Add again clipping Hue/Saturation layer.
Create new clipping layer. Pick soft, dark-brown brush and draw on the centre of her mask. Use brush with dynamic opacity for making shadows and lights.
Change blending mode of drawn layer to Multiply and Opacity to 70% – If you used lesser opacity of brush, place will be lighter and vice versa.
Add new clipping layer. With small, soft brush (ex 2px) pick white beige color. Draw contour of the mask and pattern of mask.
Again add clipping layer. You will create light on mask set. Pick soft brush #968979 color and draw on the left and right side of mask, as shown. For better effect, you can use lighter tones of beige on the edges of mask.
At the end, change blending mode to Screen.
Back below mask. Create new layer (without clipping). Use small, soft brush, with dark beige color and draw shadows below mask, on the neck and hair. Then change blending mode to multiply.
Below mask place wing. Mask it as is shown. Erase also second wing.
Add Hue/Saturation adjustment layer and make clipping mask (RMB > Create clipping mask). Set it as shown. You should make it brighter, for further transforms of colors.
Next, add adjustment layer with Color/Balance.
Then, add Brightness/Contrast layer – also clippy, because wing is still too dark.
Add new layer and make it clippy (RMB > Create clipping mask). Pick soft, brown brush and draw on the right side of wing.
Change blending mode to Screen.
On new clipping layer repeat 49 step, but use lighter brush.
Add clipping layer. You will create shadows on wings. Use smaller brush and draw below the feathers. Then change blending option to Multiply.
At the end of making wings, choose on new (without clipping) layer small (1px) white brush and draw light contour.
Place wing layers to one folder, then duplicate it (as shown). Flip whole folder horizontally and transform (ctrl+T).
Go on the top of the layers. On new layer draw with small brush some particles. Then from top menu choose Filter > Blur > Radial blur. Set amount to 2. Then decrease opacity to 75%.
Now place particles brush PSD to your file. Add Radial blur and set it as shown.